Operation Manual

33
En
Your digital receiver is equipped with two USB connectors, USB_A (Host) and USB_B (Device). The Built-in USB controller supports
the USB 2.0 standard, with a maximum of 12Mbit/s transmission speed.
9.1. Connecting and external USB 2.0 device
The USB A connector (11) on the front panel is used for connections with devices like a memory stick, USB hard disk drive, USB card
reader, or other devices compatible with the USB mass storage device class.
Below is the list of the messages related to the USB device connection:
USB - Init – Message is displayed after plugging a USB device
USB - Mounting – Message is displayed during mounting after correct initialisation is done
USB - Not Formatted – Message is displayed if USB is not formatted with FAT12, FAT16 or FAT32
USB - Access Fail – Message is displayed if there is no access to the memory
USB - Init: OK – Message is displayed if initialisation done correctly
USB - Init: Fail – Message is displayed if initialisation failed
USB - Removed – Message is displayed if USB device is removed from the USB connector
For more information about organizing fi les see the chapter Library.
Note:
Devices that are not a mass storage device type will be ignored by the digital receiver.
9.2. Copying files from a USB device to the IDL7000
1. Enter the library by pressing the “Library” button on the remote control.
If there is an external USB storage device connected, the list of available
storage devices will be displayed.
2. From the available storage devices list, select the appropriate USB device
– in this case “USB Device 0”. At this stage, you can navigate within the folder
where the fi les to be transferred are located.
9. USB