Operation Manual

4.1.2.4. Digital Audio Out

Use this option to specify desired audio type on the digital audio output (SPDIF). This option is valid for the optical and coax outputs.

Select this option with the “OK” key (6) or “Left” and “Right” directional keys.

4.1.2.5. OSD over VCR SCART

Use this option to specify if you want to have the OSD appear on the VCR SCART outputs. Select this option with the “OK” key (6) or

“Left” and “Right” directional keys.

Note:

This option is available only if TV SCART is set to RGB.

4.1.2.6. RF Modulator Audio*

You can use this option to set the modulator subcarrier frequency, when using the RF modulator output. Select this option with the “OK”

key (6) or “Left” and “Right” directional keys.

5.5MHz – PAL system

6.0MHz – PAL I system

6.5MHz – SECAM system

4.1.2.7. RF Modulator Channel*

Use this option to select modulator output channel. Select this option with the

“OK” key (6) or “Left” and “Right” directional keys or select this option with the

OK key and enter the channel wanted.

4.1.2.8. Test Picture*

Use this option to activate the test the picture on modulator output. Select

this option with the “OK” key (6) or “Left” and “Right” directional keys.

4.1.3. Hard drive Settings

This is a place where you can format or set the basic parameters of the built-

in hard disk (see picture 16).

4.1.3.1. Format the hard disk

Warning: All stored data (recorded programmes in the library) will be lost during formatting.

If you have to format the built-in hard disk, you can do this from this menu by pressing the “Red” function key (8). A short warning

message will be displayed, waiting for conﬁ rmation. In case you do not want to do format the disk press the “Red” function key (8) or

“Exit” key (22). In case you really want to format built-in hard disk press “Green” function key (9). After this, you will be asked to enter

a four digit pin code. If you enter an incorrect pin, “Wrong pin code” will be displayed. Press the “OK” key (6) or “Exit” key (22) to return

to the previous menu. Once the correct pin code is entered, formatting will begin immediately. You will then see “Please wait” until the

formatting is complete. The formatting time will depend on the hard disk size.

4.1.3.2. Default Record Folder

Use this option to select the location where all recordings should be saved. Press “OK” key (6) and select one of the folders. Here it is

also possible to open a new folder by pressing the “Green” function key (9) “Create Folder”. With the numeric keys 2-9, enter the name

of the new folder and press “OK” (6). In this menu, the letters behind the numeric keys on your remote control are activated. You may

enter the text in the same way as using a telephone keypad. Use the “Red” function key (8) to conﬁ rm the selection. Numeric key “0”

is used to exit from the folder.

4.1.3.3. Instant Replay Time

By activating this option, the live stream will be buffered and you can use rewind to watch a scene again. This only works for the channel

you are watching, and for the chosen time period (30, 60 or 90seconds). If this option is activated, the user can watch the scene again

by pressing the “Instant replay” key (10). To exit from the instant replay press “Exit” key (22) or wait until the end of the record.

Picture 16

* Important: RF modulator is an option. Your product does not have the RF modulator.