Specifications

5
Cleaning the Loader
To clean the loader, use only a clean, dry cloth, or apply a small amount of goggle lens cleaner to a
clean, dry cloth and wipe clean. Do not apply goggle lens cleaner directly to loader surfaces, as too
much contact will deteriorate plastic and cause damage.
If any paintballs break inside the hopper; do not use any liquids or chemicals to rinse out the
hopper; doing so will cause severe damage to the loader electronics.
Impeller Disassembly/Reassembly
It is best to disassemble the loader before attempting to remove the impeller.
• Step 1. Remove impeller by using a Phillips head screwdriver. Use flat head screwdriver to lift
impeller base from the shaft. Rotate impeller and lift at several points under base (Dia. I).
• Step 2. Remove impeller top and arms from base. Clean and lubricate spring with marker grease
if necessary.
• Step 3. Reassemble spring to base tab as shown (Dia. J). Install impeller top and press on the
shaft to secure. Install Phillips screw and tighten. Test impeller for function before reassembly of
the loader. If the assembly does not spring back when under load disassemble for troubleshooting.
Reassemble with the above procedure.
5. PROGRAMMING MODE
The loader has 2 settings that are adjustable by the user, which may be adjusted according to
playing conditions. The adjustable settings are Speed and Sound Sensitivity. Each setting has 3
levels; low, medium and high corresponding to 1, 2 or 3 blinks respectively.
To enter Programming Mode:
With loader OFF, press and hold the power button. The LED will then flash alternating colors
indicating you have entered the programming mode and you may now release the button. The LED
should now be GREEN to represent the Speed setting.
Exiting Programming Mode
The loader will automatically turn off after 5 seconds of inactivity. To exit programming mode
simply don’t press the button for 5 seconds and the loader will turn off.
Navigating in Programming Mode:
Each setting is indicated by a different LED color
SPEED = GREEN
SOUND SENSITIVITY = RED
To navigate to the setting you would like to check or modify, tap and release the button until
the color corresponding to that setting is displayed. For example, if the LED is currently
GREEN corresponding to the SPEED setting, and your want to get to SOUND SENSITIVITY you
would press and release the button 1 times and the LED should display RED.
Checking and Changing Settings:
First press and release the button until you get to the color corresponding to the setting you want
to change. Once there press and hold the button for 3 seconds. The LED will begin blinking to
show the current value of the setting (for example if the led blinks 2 times the current value is Med).
Once done blinking, the LED will turn off and you have 3 seconds to begin entering the new value
by pressing and releasing the button. Once done entering the new value, release the button for 3+
seconds. The LED will flash alternate colors indicating the new value has been saved. The LED
will then go back glow the solid color corresponding to the current setting chosen.
Note: If you just want to check the setting and not change it simply do not press the button to enter the new setting and
the setting will remain unchanged.
If you press and release the button more than the maximum value of the setting the maximum value
for that setting will be saved. For example if you enter a value of 5 for speed setting which has a
maximum value of 3, a value of 3 will be saved.
Programming Example – Changing sound sensitivity to 2 = Medium
-Enter programming mode as described above
- Press and release button until LED is RED
- Press and hold button until LED begins blinking
- Once LED turns off press and release button 2 times
-Wait until LED flashes alternate colors indicating setting is saved
- Wait until loader turns off automatically to exit programming
FIG.I FIG.J