R e l o a d e r B
Thank you for purchasing your new Empire Reloader B Sound-Activated 3-Speed Paintball Hopper! Should you require any technical assistance on the use of this product, or if your product needs servicing, DO NOT RETURN THE PRODUCT TO WHERE IT WAS PURCHASED. CONTACT: Paintball Solutions 570 Mantua Blvd. Sewell NJ 08080 (800) 220-3222 http://www.paintballsolutions.
R e l o a d e r B Battery Installation Remove the bolt holding the battery door. Remove the battery holder. Install batteries following the polarity markings of the holder. Connect power plug to battery pack. Re-install pack. Finally Re-install battery door bolt. The Reloader B comes with both a 4 AA battery pack with spacer and a 6 AA battery pack. The 6 AA batteries will last longer than using 4 AA batteries, but is slightly heavier. We suggest trying the 4 AA battery pack first.
R e l o a d e r Attaching The Loader You can attach your Reloader B to the markers feed neck or you may need an elbow to attach it properly. It may be necessary to sand or grind down the feed neck of the Reloader B to fit in your elbow or marker’s feed neck.
R e l o a d e r B Powering On the Reloader B 3-Speed Board Turning on: Do not load paintballs into your hopper until the hopper has been turned on. If you have already loaded the hopper, proceeding with power on sequence may result in a jam during power-up. If this happens, simply spin the rip drive manually to clear the jam. During the initial powering sequence, the motor will spin to prime the drive cone. Locate the power button on the rear control panel.
R e l o a d e r B Loading the Reloader B Be sure to attach loader to marker and turn on before adding paintballs. Hold the loader from the back with your thumb under the lip of the lid. Pinch fingers together sweeping thumb towards your fingers, lid will pop open. Load paintballs and close the lid. Rip Drive The Rip Drive is the thumbwheel located under the Reloader B. It has several uses: 1) Manually pre-tension up to 10 paintballs into your paintball gun for every revolution of the thumbwheel.
R e l o a d e r B B Emptying the Loader for Storage R e l o a d e r With the hopper turned off, turn upside down to dump the paintballs out. While upside down, rotate the Rip Drive backwards from the feeding direction to release paintballs. Do not store your Reloader B with any paintballs left inside, as doing so will stretch the drive spring and cause decreased loader performance. Release feed cone tension between long game delays. We recommend Plexus Plastic Cleaner for cleaning your Reloader B.
R e l o a d e r B General Care When storing the loader for an extended period of time, remove the battery pack completely and store in a dry place where it will not come in contact with the loader itself or any metal parts. To clean the hopper, use only a clean dry cloth, or apply a small amount of goggle lens cleaner to a clean dry cloth and wipe clean. Do not apply goggle lens cleaner directly to loader surfaces, as too much contact will deteriorate plastic and cause cracking.
R e l o a d e r B It is very important to reinstall the drive cone properly for correct loader operation. Note the drive tab (5) on the drive cone. The tab is used to catch the spring tab (4). With the drive cup (1) and spring mounted on the main shaft, put the drive cone onto the drive cup and rotate the cone clockwise until the upper and lower spring tabs hit each other. You should now have both spring tabs pressed together.
R e l o a d e r B Warranty Information Empire Paintball Products warranties this Reloader B from defects in materials and workmanship under normal use and service for a period of 90 days from original purchase date. The manufacturer agrees to repair or replace any part which has been found to be defective. The outer shell is not covered under this warranty if it is broken due to misuse, dropped, or collided with another object.
