Operation Manual

To find out the water hardness level in your area, contact your local water company. Adjust the salt consumption according to the
table on the next page.
Note! Hardness level is adjusted to level 4 as a factory setting.
• Turn the machine on.
• Press and hold the Start/Pause-button for 5 seconds to enter the mode for setting the salt consumption. This must be set within
60 seconds after turning the machine on.
• Set the level of water hardness by pressing the Start/Pause-button repeatedly. U kunt het niveau instellen door herhaaldelijk op
de Start/Pauze-knop te drukken. Use the table of water hardness level settings on the next page.
• After adjusting the level of water hardness, press the On/Off button to confirm and store the setting.
Table of water hardness level settings
Water
hardness
level
German
hardness
°dH
French
hardness
°fH
British
hardness
°Clark
Program indicator
hardness level
Salt consumption
(gram/cycle)
H1 0-5 0-9 0-6
● indicator light RINSE on
L1
H2 6-11 10-20 7-14
● indicator light FAST 90 MIN on
L2
H3 12-17 21-30 15-21
● indicator light FAST 90 MIN on
● indicator light RINSE on
L3
H4 18-22 31-40 22-28
● indicator light DELICATE on
L4
H5 23-34 41-60 29-42
● indicator light DELICATE on
● indicator light RINSE on
L5
H6 35-55 61-98 43-69
● indicator light DELICATE on
● indicator light FAST 90 MIN on
L6
Prior to using the machine for the first time please check whether the electricity and supply water specifications match the values
indicated by the installation instructions for the appliance.
Remove all packaging materials inside the machine.
Fill the salt reservoir and fill up with water until it almost overflows. Set the water hardness setting.
Fill the rinse aid reservoir.
For a good washing result, the dishwasher needs soft, i.e. less calcareous water. Otherwise, white lime residues will remain on the
dishes and the interior of the dishwasher. This has a negative effect on your applinace’s washing, drying and shining performance. For
this purpose, dishwasher salt is used.
• Remove the lower basket and unscrew the cap of the salt reservoir
(1).
• Place the provided funnel into the opening and fill with salt till the
overflow level, about 1.5 kg (2).
• Fill the reservoir before first use with water. It is normal for a little
water to flow out of the opening when doing this.
• Screw the cap back on firmly.
ATTENTION!
• Remove any spilled salt and run a full program to prevent corrosion
to the bottom.
• Refill the salt reservoir when the indicator light of the salt reservoir
lights up.
before first use
3
FILLING THE SALT RESERVOIR
SETTING THE SALT CONSUMPTION
1 2
32 • English