User Manual

Problem Possible cause Possible solution
The cap of the salt reservoir is not
closed correctly.
Make sure that the cap of the salt
reservoir is closed firmly.
The dishes are not dry. The selected program does not
include drying.
Choose a program that includes
drying. Refer to section
'Programs' .
The level of rinse aid consumption is
set too low.
Adjust the level of rinse aid
consumption. Refer to section
'Setting the level of rinse aid
consumption'
.
There are rust stains on the dishes. The stainless steel quality of the
dishes is insufficient.
Make sure that you only clean
dishwasher-safe dishes in the
appliance.
There is a high level of salt in the
water.
Adjust the level of salt consumption.
Refer to section
'Setting the level of
salt consumption'
.
The cap of the salt reservoir is not
closed correctly.
Make sure that the cap of the salt
reservoir is closed firmly.
Any spilled salt during filling of the
salt reservoir was not cleaned
immediately.
Make sure that you clean any spilled
salt immediately and run a full
program to prevent corrosion.
There is a problem with the
grounding of the mains supply.
Contact an authorized electrician.
FAULT CODES
If the appliance has a fault the start/pause button or one or more of the program-step indicators blink.
Fault Start/pause
button
Wash Dry End Notes
Overflow/Leakage - Blink - Blink During normal operation only leakage is
shown.
Drain time out Blink - - Blink
Presence flow
meter impulses
- - - Blink
Absence flow meter
impulses
- Blink - - During normal operation this fault is not
shown.
Empty level Blink - - -
Re-fill time out Blink - - -
NTC ca/cc Blink Blink - -
Overheating Blink - Blink -
Unsuccessful
heating
- Blink Blink - During normal operation this fault is only
shown at the end of a program.
Parameter set salt
incorrect
Blink Blink - Blink During normal operation this fault is not
shown.
CK parameters Blink Blink Blink Blink
High voltage Blink Blink Blink -
Low voltage - Blink Blink Blink
52 • English