User Manual

8 Extra information
WATER HARDNESS LEVEL SETTINGS (SALT CONSUMPTION)
Level German hardness
[dH]
French hardness [dF] British hardness [dE] Indicator on
1 0-5 0-9 0-6 Program-step indicator Wash
2 6-11 10-20 7-14 Program-step indicator Dry
3 12-17 21-30 15-21 Program-step indicator End
4 18-22 31-40 22-28 Program-step indicators Wash
and Dry
5 23-34 41-60 29-42 Program-step indicators Wash
and End
6 35-50 61-90 43-63 Program-step indicators Dry
and End
RINSE AID CONSUMPTION SETTINGS
Level Number of rinse aid doses that is dispensed Indicator on
1 Rinse aid not dispensed Program-step indicator Wash
2 1 dose Program-step indicator Dry
3 2 doses Program-step indicator End
4 3 doses Program-step indicators Wash and Dry
5 4 doses Program-step indicators Wash and End
9 Troubleshooting
GENERAL TROUBLESHOOTING PROCEDURE
1. Try to find a solution for the problem with the help of the troubleshooting table and the fault codes.
2. If you cannot find a solution for the problem, reset the appliance. Refer to section
'Resetting the program' .
3. If the fault code keeps re-occuring, contact the Inventum-servicedienst.
TROUBLESHOOTING TABLE
Problem Possible cause Possible solution
The program does not start. The mains plug is not connected. Connect the mains plug.
There is a problem with the fuse. Do a check on the fuse box.
There is no water supply. Open the water tap.
The door of the appliance is open. Close the door.
The appliance is switched off. Start the appliance. Refer to section
'Starting the appliance' .
The water inlet hose and filters are
clogged.
Make sure that the water inlet hose
and the filters are not clogged.
50 • English