Operation Manual

English • 21
ELECTRICAL CONNECTION
Attention: this hob includes a power cord with a plug. The connection is a 1 fase-connection.
• Check that the voltage in your home corresponds with the voltage printed on the bottom of the appliance.
• The earthing of the appliance is compulsory by law.
• Attention: the connection point must always be accessible.
problems & solutions
8
If there is an error, an error code will be shown at the displays.
Error code Cause Solution
E1 Supply voltage is too high. Have the installation checked by a qualified electricien.
E2 Supply voltage is too low. Have the installation checked by a qualified electricien.
E3/E4 The cooking zone is overheated.
Wait for the temperature of the cooking zone to drop and switch it on
again.
E5/E6 The hob is overheated. Switch the appliance off and let the cooking zones cool down.
F3/F4
F5/F6
F7/F8
Induction sensor is defect. Contact the service department of Inventum.
F9/FA
FC/FD
Coil temperature sensor is defect. Contact the service department of Inventum.