Operation Manual

18 • English
CLEANING OR REPLACING THE HEPA FILTER
The HEPA filter cleans the air one last time before it leaves the vacuum cleaner. Clean the HEPA filter at least
once per six months or when it is very dirty. Replace a damaged HEPA filter with a new original HEPA filter.
• Open the grid [23] that covers the HEPA filter by pushing the clip.
• Pull the clip back and take out the HEPA filter [24].
• Rinse the HEPA filter under lukewarm water and let it air dry completely. Do not use any cleaning agents
or brushes.
• Put the HEPA filter back into place, when dry, or replace it by a new one.
• Replace the grid. Make sure that the grid is properly placed.
Attention
• Use the vacuum cleaner only when the filters and a dust bag are in place. If not, it can lead to loss of
suction power or damage to the motor.
• Unplug the vacuum cleaner before cleaning or replacing the filters.
• Torn filters or filters that do not fit properly can cause damage to the engine. Replace a damaged filter by
an original new one.
• Do not clean the filters in a dishwasher.
• Do not use a hair dryer to dry the filters.
STORAGE
For easy storing the vacuum cleaner.
• Rewind the cord by pressing the cord rewinding foot pedal
.
• Push the slide button on the telescopic tube upwards and push the telescopic tube together to make it
shorter. Release the slide button and let the tube snap into place.
• Park the vacuum cleaner and slide the floor nozzle in the attachment at the back of the device [25].
24
23
25
Problem Possible cause Solution
The suction has decreased. The dust collector is full. Empty the dust collector.
The filters are clogged. Replace the motor filter for a new one or clean
the HEPA filter according to the instructions.
The button for the suction power is not set
to max or the extra suction power control
on the handle is open.
Set the suction power to maximum or close the
control for extra suction power on the handle
of the hose.
It is hard to move the brush over
the surface.
The suction power is set too high. Decrease the suction power or open the extra
suction power control on the handle.
The button on the brush is set on the wrong
setting.
Make sure the brushes are retracted on carpet.
Make sure the brushes are down on a hard floor.
The vacuum cleaner makes
more noise.
The tube or hose is clogged. Disconnect the tube and the hose and empty
them.
The motor filter or HEPA filter is clogged. Replace the motor filter.
Clean or replace the HEPA filter.
The cyclone system is clogged. Empty the dust collector and clean the cyclone
system according to the instructions.
frequently asked questions
7