User Manual

FAULTCODE DESCRIPTION CHECK
P1 - Intensive P2 - Fast 50 min P3 - Eco P4 - Rinse
- Half load
Inadequate water supply • Check whether the tap is fully open and there is nothing
blocking the water mains.
• Close the tap, remove the input hose and check whether it
is clogged.
• Start the dishwasher again. Contact the service department
of Inventum when the error remains.
Pressure system failure. • Contact the service department of Inventum.
Water supply is not stopping. • Close the tap.
• Contact the service department of Inventum.
The waste water can not be
discharged.
• The water discharge hose is clogged.
• The filters might be clogged.
• Turn the dishwasher off. Reset the dishwasher’s program
and check the filters and the discharge hose. Restart the
dishwasher.
• Contact the service department of Inventum when the error
remains.
The water temperature is not
correct. Heating defect.
• Contact the service department of Inventum.
Safety is activated against water
overflow.
• Turn off the dishwasher and close the tap.
• Contact the service department of Inventum.
Faulty electronics. • Contact the service department of Inventum.
Overheating error. • Contact the service department of Inventum.
Faulty heat sensor. • Contact the service department of Inventum.
English
• 41