Operation Manual

step by step installation
8
1. Install the furniture door to the outer door of the dish washer using the brackets provided - illustration 7-1. Refer to the installation
template for the positioning of the brackets.
2. Adjust the tension of the door springs by using an Allen key turning in a clockwise motion to tighten the left and right door springs.
Failure to do this could cause damage to your dishwasher - illustration 7-2.
3. Connect the inlet hose to the cold water supply.
4. Connect the drain hose. Refer to the diagram on the installation template - figure 6.
5. Plug the appliance in.
6. Affix the condensation strip under the work surface of the cabinet. Please ensure the condensation strip is alligned with the edge of
the work suface - illustration 7-3.
7. Place the dishwasher into position - illustration 7-4.
8. Level the dishwasher. The rear feet can be adjusted from the front of the dishwasher by turning the Allen screw in the middle of the
base of the dishwasher using an Allen key - illustration 7-5A.
To adjust the front feet, use a flat screw driver and turn the front feet until the dishwasher is level - illustration 7-5B.
9. The dishwasher must be secured in place. There are two ways to do this:
A. Normal work surface: Put the installation hook into the slot of the side panel and secure it to the work surface with the wood
screws - illustration 7-6.
B. Marble or granite work top: Fix the side with the screw - illustration 7-7.
4
Fu rniture door
1
C ondensa tion strip
2
5
B
3
6
7
A
7
50 • English