Operation Manual

DRAIN HOSE CONNECTION

Insert the drain hose into a drain pipe with a minimum diameter of 40 mm, or let it run into the sink, making sure to avoid bending or

crimping it. The top of the hose must be less than 1000 mm.

Counter

Note: the top of the

hose must be less

than 1000 mm.

front

drain pipe

please ﬁx the drain hose either way A or B

ELECTRICAL CONNECTION

Ensure the voltage and frequency of the power corresponds to those on the rating label. Only insert the plug into an electrical socket

which is earthed properly. Use the required fuse 10 amp.

COLD WATER CONNECTION

Connect the cold water supply hose to a threaded 3/4 (inch) connector and make sure that it is fastened tightly in place.

If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the water is clear.

This precaution is needed to avoid the risk of the water inlet to be blocked and damage the appliance.

Attention: the dishwasher can not be connected to a warm water supply.

English • 49