Operation Manual

46 • English
• The safety during use can only be guaranteed when the appliance is installed correctly and according to the regulations. The
installer is responsible for any damage caused by a faulty installation.
• The electrical connection must be made by a qualified electricien. This person is aware of the national and local regulations the
installation must comply with.
• The appliance can only be used in combination with a grounding conductor connection. The manufacturer accepts no
responsibility for any malfunction or damage caused by incorrect electrical installations.
• The connection cable must hang freely. Do not tie the power cable or pass it along sharp edges. If there is an oven installed below,
pass the cable along the rear corners of the oven to the connection box. It must be positioned so that it does not touch any of the
hot parts of the hob or the oven.
• The connection point, the wall socket and/or plug must always be accessible.
• Damage caused by incorrect connection, incorrect use or incorrect fitting is not covered by the guarantee.
• Attention: any change to the appliance’s interior, including fitting and changing the power cable, must only be performed by a
qualified electricien.
1. Install the dishwasher at the desired location taking into account the length of the inlet and drain hoses and the power cord. Also
check the installation instructions on the accompanying installation template. Preparations should be made before placing the
dishwasher at it's final location. Choose, if necessary, one side of the cabinet to facilitate the connection of drain hoses of the
dishwasher - figure 1.
2. If the dishwasher is installed in the corner of the cabinet, there should be some space left when the door is opened - figure 2.
3. The aesthetic wooden panel can be fixed on the outer door according to figure 3.
4. Install the hook on the aesthetic wooden panel and put the hook into the slot of the outer door of the dishwasher - figure 4a. After
positioning the panel, fix the panel onto the outer door with the screws and bolts - figure 4b.
5. The door springs are set at the factory to the proper tension for the outer door. When the aesthetic wooden panel is placed, you
will have to adjust the door spring tension. Rotate the adjusting screw to drive the adjustor to strain or relax the steel cable -
figure 5. The door spring tension is correct when the door remains horizontal in the fully opened position yet rises to a close with
the slight lift of a finger.
installation instructions
7
90 90
820 mm
580 mm
100
600 mm
Electrical, drain and
water supply line
entrances
80
Space between cabinet
bottom and oor
1
DishwasherDishwasher
Door of
dishwasher
Cabinet
Minimum space of 50 mm
2
Cabinet dimensions less
than 5 mm between the
top of the dishwasher and
cabinet and the oudter
door must be aligned to
the cabinet.
Minimum space when the
door is opened.