Operation Manual

• If the door of your appliance does not close properly, check if the appliance
stands level on the floor. If not, adjust the adjustable feet and ensure its
stable position.
Make sure that the indoor plumbing is suitable for installing a dishwasher. Also,
we recommend that you fit a filter at the beginning of the water supply in your
house to avoid any damage to your appliance because of any contamination
(sand, clay, rust, etc.) that might occasionally carried in through the mains
water supply.
• Always use the new water inlet hose supplied with your appliance. If you are
using the new water inlet hose, run water through it for a while before making
the connection.
• Connect the water inlet hose directly to to the water inlet tap. The pressure
supplied by the tap should be at a minimum of 0,03 Mpa and at a maximum
of 1 Mpa. If the water pressure is above 1 Mpa, a pressure-relief valve should
be fitted inbetween.
• After the connections are made, the tap should be turned on fully and
checked for water leakage.
• The appliance is supplied with an double-walled aquastop. The system
automatically cuts off the water supply if the water inlet hose starts to leak
and the space between the walls is filled with water. Make sure not to cut into
the aquastop or that it gets twisted or stuck.
• The water drain hose can be connected either directly to a drain pipe with
a minimum diameter of 4 cm, or let it run into the sink, making sure to avoid
bending or crimping it. The free end of the hose must be at a height between
40 and 100 cm and must not be immersed in water.
• Close the water tap after each use.
Warning: When a drain hose longer than 4 m is used, the dishes might remain
dirty. In that case Inventum will not accept responsibility.
• The plug of the appliance must be connected to an earthed socket. Make
sure that the voltage and the frequency values for the current in the home
correspond to those on the rating plate. Inventum is not responsible for
damage when using the appliance with a socket that is not earthed.
• The electrical installation in the home must be provided with a fuse of 16
Amp. The dishwasher is designed for connection to 220 -240 V ~50 Hz.
The appliance should not be plugged in during positioning. Always use the
supplied plug.
• The appliance’s electrical cable should only be replaced by an authorised
service or an authorised electrician. Failure to do so may lead to accidents.
CONNECTING TO THE WATER TAP AND DRAINAGE
ELECTRICAL CONNECTION
32 • English