User Manual

TROUBLESHOOTING TABLE
Problem Possible cause Possible solution
The appliance does not start.
There is no mains supply.
• Do a check if the mains plug is
correctly connected to the mains
socket.
• Make sure that the mains supply
is on.
The appliance is locked.
Unlock the appliance. Refer to
section 'Locking and unlocking the
appliance'
.
The touch buttons are covered with
water or dirt.
Clean the appliance. Refer to section
'Daily cleaning' .
The operation indicator on the
control panel shows U.
There is no pan on the cooking zone. Put a pan on the cooking zone.
The pan is not suitable for an
induction appliance.
Use a pan that is suitable for an
induction appliance. Refer to section
'Requirements for pans' .
A cooking zone switches off
automatically. The operation
indicator shows H.
The maximum cooking time is
reached. Refer to section 'Automatic
switch-off times'
.
1. Start the appliance. Refer to
section 'Starting the appliance' .
2. Select a cooking zone. Refer to
section 'Using a cooking zone' .
The operation indicator on the
control panel shows Lo.
The appliance is locked.
Unlock the appliance. Refer to
section 'Locking and unlocking the
appliance'
.
BREAKDOWN CODES
The breakdown codes are shown on the timer indicator on the control panel.
Breakdown code Possible cause Possible solution
E3 / E6 The appliance is overheated.
Let the appliance cool down before
restarting it.
E7 / E8 There is a defect in the mains supply.
Do a check on the voltage of the
mains supply.
U
There is no pan on the appliance or the pan is
not suitable for an induction appliance.
Place a pan or use a pan that is
suitable for an induction appliance.
Refer to section 'Requirements for
pans'
.
The appliance or a cooking
zone has turned itself
off unexpectedly, a tone
sounds and a breakdown
code is displayed.
A technical defect. Please write down the breakdown
code, unplug the appliance and
contact Inventum-servicedienst.
38 • English