Operation Manual

troubleshooting
6
What to do in case of a malfunction? In most cases, you will be able to correct these faults easily yourself. Please check the solutions
below before contacting the Inventum service department.
The motor is not running
• Is it plugged in correctly?
• Is there a power outage?
• Check the electrical installation.
The performance of the cooker hood is not correct and makes more nois.
• Is the diameter of the exhaust-air pipe correct?
• Is the duct blocked?
• The diameter of the duct must be 150 mm. A smaller diameter can negatively influence the suction of the motor.
• Are the grease filters clean?
• Are the carbon filters not replaced within the last 6 months? Replace the carbon filters.
• Is there enough air supply to replace the extracted air?
22 • English
CHANGING A LED STRIP
When a LED strip of the cooker hood is broken, you can replace it yourself. Follow these steps:
• Unplug the appliance or remove the connector fuse.
• Remove the grease filters - figure 1.
• Push the complete LED strip from the outside to the inside of the cooker hood and slide it towards the opening of the grease filter.
downwards - figure 2. Unplug the broken LED strip from the transformer and replace the complete LED strip with a matching type
(2.1W, LED).
• Plug the new LED strip in the transformer and slide and push the complete LED strip gently back in its place.
• Replace the grease filters and plug the appliance in.
1 2