Users Manual

ISM14585-EVB User’s Manual
DOC-DS-14585-EVB-201911-3.6
Confidential Inventek Systems
Page 8
Class 2 permissive changes must be performed under Inventek’s grant, and therefore
must be done in cooperation with Inventek. In addition to this document, Inventek
recommends verifying the schematic board design with Inventek Engineering once the
schematic is complete for further review and validation.
If it is desired to add a connector or U.FL connector in the RF path or change the antenna
to one of the same type (chip) with equal or less gain, customers can do so without refiling.
Other changes such as a different antenna or adding an antenna diversity switch will
require filing for a Class 2 permissive change. Any Class 2 permissive changes must be
performed under Inventek’s grant, and therefore must be done in cooperation with
Inventek. In addition to this document, Inventek recommends verifying the schematic
board design with Inventek Engineering once the schematic is complete for further review
and validation.
Inventek also provides customers additional certifications for specific countries upon
request and an agreed upon service fee.
3.6.1 FCC and IC Regulatory Information
• Model: ISM14585-L35-P8
• FCC ID: 07P-14585
• IC: 10147A-14585
This module is limited to OEM installation only.
OEM integrators must ensure that the end-user has no manual instructions to remove or
install the module. OEM’s must comply with FCC marking regulation part 15 declaration of
conformity (Section 2.925(e)).
This module is to be installed only in mobile or fixed applications (Please refer to FCC CFR
47 Part 2.1091(b) for a definition of mobile and fixed devices).
Separate approval is required for all other operating configurations, including portable
configurations with respect to FCC CFR 47 Part 2.1093, and different antenna
configurations.
The antennas used with this module must not be co-located or transmit simultaneously with
any other antenna or transmitter, except in accordance with FCC multi transmitter product
procedures. The ISM14585-L35-P8 Module has been designed to operate with the following
antennas and gains. Use with other antenna types or with these antenna types at higher
gains is strictly prohibited.