User's Manual

locations, and so on. If you are uncertain of the policy that applies to the use of this product, ask for
authorization to use it before you turn it on.
Federal Communications Commission notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment
o and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
●
Reorient or relocate the receiving antenna.
●
Increase the separation between the equipment and the receiver.
●
Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
●
Consult the dealer or an experienced radio or television technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
For questions regarding this product, write to:
HP Inc.
1501 Page Mill Road
Palo Alto, CA 94304
or call HP at 650-857-1501.
To identify this product, refer to the part, series, or model number found on the product.
Modications
The FCC requires the user to be notied that any changes or modications made to this device that are not
expressly approved by HP Inc. may void the user's authority to operate the equipment.
Cables
Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods in order
to maintain compliance with FCC Rules and Regulations.
Products with wireless LAN devices
This product may be equipped with a wireless LAN device. This device must not be co-located or operating in
conjunction with any other antenna or transmitter.
16 Chapter 2 Regulatory notices for desktops, thin clients, and personal workstations