User's Manual

68
Checking the Wi-Fi Connection
You can check the current wireless connection status after
connecting to a Wi-Fi Network.
1. Select Start > Settings > Connections tab > WiFi Network.
2. Information such as the SSID (the Wi-Fi network name)
and the wireless network signal strength will be shown
in a summary screen.
3. Select other tabs to check IP information, change power
saving settings or review other advanced settings.
4. Select OK.
Conguring Wi-Fi Settings
You can congure wireless networks on the device by adding new Wi-Fi connections
and editing currently available networks.
Creating a Wireless Connection
Some Wi-Fi networks are hidden. You might sometimes need to enter the network
settings manually. To set up a new Wi-Fi network connection, you will rst need to
have your home router settings or information from your administrator about joining
the corporate Wi-Fi network.
1. After turning on Wi-Fi on the device, do either of the following:
• Open Wireless Manager, select Menu > Wi-Fi Settings.
• Select Start > Settings > Connections tab > Wi-Fi .
2. In Wireless tab, select Add New.
3. Enter the Network name, select a Network type, then select Next. If you want to
connect to another device instead of a network through an access point, select
This is a device-to-device (ad-hoc) connection.
4. Enter required information, then select Next.
5. Select Use IEEE 802.1 x network access control to use EAP (Extensible
Authentication Protocol). Select EAP type: PEAP or Smart Card or Certicate.
6. Select Finish.