User's Manual

Power Source & Charger
Connect device with power source as the picture
1
below.
LED indicator stays orange, indicating that it is
charging.
•
You can charge the device by connecting connector A with
computer USB port
.
LED indicator light turns out
2
indicating that Charging is complete.
The full charging time is about
4 hours 30 minutes.
•
The charging time will vary with the conditions of use and
temperature, if you are using while charging, charging time
will be extended.
Unplug the USB cable.
3
Micro SD Card
You can insert a Micro SD card to expand the memory.
Insert:
switch off the device first.
Gently push the card into the card jack
until you hear a sound.
Remove
:
switch off the device first.
Gently press the card until you hear a
sound.
Connector A
Connector B
•
Main power is a rechargeable Li-batteries Inside.
• Rechargeable battery can be used repeatedly, but it will eventually
wear out. When the battery life is shortened, you should buy and
replace it with a new one.
• Do not disassemble the machine to replace the battery.
• It is good for the device to use the specified adaptor of the device.
• Please recycle batteries in accordance with local regulations.
Use of the battery
When transfer or open files on Micro SD, in order to avoid data loss
or abnormal of the data . Please make sure the power is off, before
inserting and removing card.
Power On/Off
Power Off:
Long press ON/OFF key and then choose "Power off"
Interval:
When the device is unused, please press ON/OFF key
gently. The screen enters power-saving mode.
Awakening:
On power-saving mode, press ON/OFF key to
awaken this mode.
Power On:
Long press ON/OFF key till the start-up picture is
shown.
Stylus
Stylus plugs in the pen slot.
Please pull the stylus out by your finger and put it
back to the slot to avoid loosing.
2