User Manual

Philips 868 User Guide
Page 53 of 89
‧ Night mode: Allows you to set the night mode On or Off. When set to be On, the camera
sensor is more sensitive to the light.
‧ Picture mode: Allows you to chose a desired picture mode from the following list.
- Normal: to take a normal picture without frame.
- With frame: to take a picture with frame. Open an exclusive list so users can
select a desired frame. The frame selected is then shown in the viewfinder.
(Note: This option is only available for wallpaper pictures.)
- Multishot: to take multiple pictures by keeping the OK key pressed when in
the viewfinder. Open an On/Off screen. (This option is only available for
VGA/QVGA mode. At most 10 continuous frames can be taken.)
(Note: pictures taken by multishots can only be saved on the
external memory card.)
‧ Self-timer: Allows you to set the Self-timer option On or Off. The countdown starts at 5
seconds (this value can not be changed). A sound is played 2 seconds before the picture is
taken, then again when it’s actually shot.
‧ Special effects: Allow you to choose one of the available effects: “No effect”, “Sepia”,
“Negative”, “B&W”, “Blue” and “Edge”.
‧ White Balance: Allows you to choose one of the available white balance modes: Auto,
Sunny, Cloudy, Incandescent, and Fluorescent.
‧ Shooting sound: Allows you to select the shooting sound for taking a picture.
‧ Storage location [available only when memory card is present]: Allows you to define where
to store the camera pictures. You are offered to choose between Memory card and Phone
memory.
‧ Date and time: Alllows you to set whether to add date and time on the bottom right of a
taken picture.
‧ Electricity frequency: Allows you to choose the electricity frequency for taking pictures.
You can choose between 50 Hz and 60 Hz.
Take a picture
If the self-timer option is set to be Off, once the camera is activated, press the OK key or the
camera key to take a picture. The taken picture is to be automatically saved in the storage
location you have set under the default name picture_date_time(seconds).jpg. After the
picture is saved automatically and displayed on the screen, you can press the left soft key
[Options] to further access the following options:
‧ Send: to send the picture by infrared or MMS.
‧ Set as wallpaper: to set the highlighted picture as the wallpaper for the main display.
‧ Set as sub wallpaper: to set the highlighted picture as the wallpaper for the sub display.
‧ Add to contacts: to attach the taken pictures to a contract entry.