User Manual
Table Of Contents
- Important Information
- Regulatory Information
- USA FCC Information Concerning Radio Frequency Interference
- Europe - EU Declaration of Conformity
- Overview
- System requirements
- Unpacking the boxes
- Assembling and charging the network hubs
- Before you begin
- Setting up your TI-Navigator™ network the first time
- Before you begin
- Hardware type and Ethernet adapter type
- Connecting the cables to the access point
- Starting the wizard
- Identifying your hardware and selecting a channel
- Identifying the network connection
- Configuring an Ethernet port
- Configuring a USB port
- Setting up your classroom network
- Activating the access point
- Activating Type 2 network hubs
- Activating Type 1 network hubs
- Registering your TI-Navigator™ system
- Installing the calculator operating system
- Connecting the calculators to the hubs
- Installing software Apps on the calculators
- Technical information
- Troubleshooting
- Resetting the Type 2 access point
- Resetting the Type 1 access point
- Texas Instruments Support and Service
- Battery Precautions for Calculators
- Battery Precautions for Rechargeable Battery Packs
- Texas Instruments (TI) Warranty Information
- TI LearningCheck 3.x License Agreement
57
Battery Precautions for Rechargeable Battery
Packs
The TI-Navigator™ network hub contains a Lithium Ion battery pack.
Adherence to the following instructions and cautions will help you get
the most from your battery pack.
Contact TI if you have problems with the battery.
WARNING: THERE IS A RISK OF EXPLOSION IF REPLACED BY AN
INCORRECT TYPE. REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE
RECOMMENDED BY TEXAS INSTRUMENTS. DISPOSE OF USED BATTERIES
ACCORDING TO LOCAL REGULATIONS. DO NOT RECHARGE,
DISASSEMBLE, CRUSH, HEAT ABOVE 140º (60º C), OR INCINERATE.
Always follow the following guidelines:
• Replace only with TI-specified battery pack.
• Use only in TI-Navigator™ network hubs.
• Do not disassemble, puncture, crush, or incinerate batteries.
• Charge batteries only with an approved charger designed for use
with your Texas Instruments product.
• Do not place non-rechargeable batteries in a battery recharger.
• Properly dispose of used batteries immediately. Do not leave them
within the reach of children.
• Remove batteries for disposal in accordance with your local
regulations before disposing of the TI-Navigator™ system.
Storage
• Remove batteries from the calculator.
• Store in controlled climate conditions between 20 degrees C and 35
degrees C.
• Avoid high temperature storage conditions. Do not store under
sunlight or in an automobile.
• Recharge after storing if rechargeable.
• Do not leave batteries within reach of children.
InstallationGuide.book Page 57 Wednesday, May 3, 2006 10:19 AM