User Manual
Table Of Contents
- Important Information
- Regulatory Information
- USA FCC Information Concerning Radio Frequency Interference
- Europe - EU Declaration of Conformity
- Overview
- System requirements
- Unpacking the boxes
- Assembling and charging the network hubs
- Before you begin
- Setting up your TI-Navigator™ network the first time
- Before you begin
- Hardware type and Ethernet adapter type
- Connecting the cables to the access point
- Starting the wizard
- Identifying your hardware and selecting a channel
- Identifying the network connection
- Configuring an Ethernet port
- Configuring a USB port
- Setting up your classroom network
- Activating the access point
- Activating Type 2 network hubs
- Activating Type 1 network hubs
- Registering your TI-Navigator™ system
- Installing the calculator operating system
- Connecting the calculators to the hubs
- Installing software Apps on the calculators
- Technical information
- Troubleshooting
- Resetting the Type 2 access point
- Resetting the Type 1 access point
- Texas Instruments Support and Service
- Battery Precautions for Calculators
- Battery Precautions for Rechargeable Battery Packs
- Texas Instruments (TI) Warranty Information
- TI LearningCheck 3.x License Agreement
56
Resetting the Type 2 access point
You might need to reset the access point to a known state in order to
add it to the network.
1. With the power adapter connected, insert the end of a ball-point
pen or paper clip though the small hole on the side of the access
point labeled
Reset, and gently press and hold the reset button
inside the unit.
2. Hold the reset button until the Activity LED stops blinking and the
Link LED goes off.
Resetting the Type 1 access point
You might need to reset the access point to a known state in order to
add it to the network.
1. Position the access point so that the front side faces you, with the
row of five LEDs in the lower-right corner.
2. Disconnect the Ethernet crossover cable and the power adapter.
3. While pressing in the switch labeled S1, connect the power adapter
to the access point.
4. Continue pressing S1 until both the 2nd and 4th LEDs blink
simultaneously (approximately 30 seconds).
5. Release S1 and wait until the three rightmost LEDs blink
simultaneously (approximately three minutes).
6. Unplug the power adapter from the power jack on the access point.
Reset
button
InstallationGuide.book Page 56 Wednesday, May 3, 2006 10:19 AM