User's Manual

XCRF-860 USER’S MANUAL
25
Select “TCP”, “USB”, or "Com1” etc. under “communication
port selection”, as illustrated in Fig. 6.6.
6.6. Port Configuration
If “Serial Communication” is selected, the Serial Port should
be connected to the serial port on the PC via serial cable. Select
the serial number listed on the pop-down manual.
If select “TCP”, input the XCRF-860 reader’s IP.
If the Reader's IP is not configured yet, configure the IP address
by completing the following steps.
1） Connect the Communication Port
Connect the serial pork on the XCRF-860 reader to the port
on the Host. Select “Serial Communication Mode” as
“Communication Port” as illustrated in Fig. 6.7:
Fig. 6.7 The Communication Port Selection
2） IP Address Configuration
Select “config” －> “Config Reader parameter”, configure
the IP address on the Pop-up manual as illustrated in Fig. 6.8.