User's Manual

7
Chapter 2: Installation
In this chapter we introduce the installation and testing of
XCRF-500 reader series. Before installation and testing,
operator should read the article of “ radio frequency (RF)
radiation” (Section 6.1) of this handbook.
2.1 Appearance of XCRF-500 reader series
Appearance of XCRF-500 reader series is shown as figure 2-1
(a) and figure 2-1 (b). There are power switch , interface of
power supply, an serial interface, a 10M network interface and
a control interface on the front panels of XCRF-500 reader
series. There are 5 LED indicators for working status of reader
on the upper panels of XCRF-500 reader series. There are 2
N-joints which connect transmitting and receiving antenna of
reader, except that there are also 2 extend N-joints on the back
panels of XCRF-500 reader series.