User's Manual

User’s Manual
XC-RF812 Reader
15
6 Operating RFID Demo
After being installed, the screen appears as follows:
Figure 6-9
Click “Finish” to Complete software installation, and a desktop shortcut of “RFID
Demo” appears.
6.4 Demo Software Operation
6.4.1 Start screen
1. Start the software, and you can establish a network port or a USB connection. If
the equipment’s IP address is uncertain, you can use the device’s USB interface
to establish a connection. Before using USB communication, you need to install
the corresponding driver “linux-cdc-acm.inf”. After the installation is complete,
you can navigate “My Computer -> Properties -> Hardware -> Device Manager
-> Ports “ to view the virtual serial ports, and select the corresponding serial port
connection as shown in Figure below: