User's Guide

LSP3A Clear User’s Guide
It is only for internal use and shall not be spread without permission
24
By default the IP address is 192.168.9.23 (IPv4 Automatic Private IP
Addressing). Ask your network administrator to obtain a static IP address for
each of the pedestals connected to your local network.
The LSP3A configuration will be carried on using a host computer connected to the local
Ethernet network.
You can localize the each gate thanks to their IP address. Their on site
location must be known to configure and set them as Slaves or Master.
5.4 Configuration of the LSP3A Clear
“Library Pedestal Configuration Tool” is the software tool used to monitor and configure the
LSP3A pedestal.
The whole LSP3A configuration is carried on from a host computer connected to the local
area network. Each LSP3A is addressed thanks to its own IP.
In a configuration with several pedestals, as all pedestals are set as master
by default, they will mutually perturb when powered on. So the first step will
be to set the appropriate pedestals as slaves.
Before you configure the whole LSP3A, you need to have a Clear vision of
which pedestals will be masters or slaves. (Refer to section 5.2
“Understanding the LSP3A Synchronization Process”)