User's Guide

LSP3A Clear User’s Guide
It is only for internal use and shall not be spread without permission
10
4.1.2 Electrical Safety Rules
The LSP3A Clear is powered up via a Mains Supply IEC Cord.
A group of up to 5 Pedestals can be daisy chained and powered via a single IEC power
cord connected to a wall socket. The mains wall socket should provide at least 2 Ampere and be
protected by a differential circuit breaker limiting the current to 5 Ampere maximum.
Figure 4.1 here below shows how to connect the LSP3A pedestals to the mains.
Figure 4.1: Safety Electrical Installation Using Power Cord
The electrical installation must be carried on by qualified personnel only.
For each country where installation takes place, an adequate IEC power
supply Cord must be used, fitting the local wall socket layout.
4.1.3 Network cable installation
The LSP3A delivery package does not include an Ethernet cable to connect to a Local Area
Network for remote operation. We recommend the use of a Shielded Ethernet cable, UTP-Cat 5.