User's Guide

LSP3A Clear User’s Guide
It is only for internal use and shall not be spread without permission
9
4 Installation
4.1 Recommendations before Installation
This section describes how to install the LSP3A Clear.
4.1.1 Wire Feed Sheaths
Within the framework installation you need at least a power supply cable sheath and an
Ethernet cable sheath to connect to the Ethernet network. These sheathed cables will be located
at the bottom center of the pedestal as shown in Figure 4.10.
If needed according to the installation configuration, extra sheathed cables need to be
placed for wire synchronization, Trigger cable and to remotely switch the RF on & off and I/O
cables to drive external devices (Camera, Remote alarms…).
The LSP3A is delivered without any IEC terminated plug power supply cable or
Telecommunication cable. It is up to the Local installation personnel to use the appropriate IEC
Power Cord according to local electrical regulations.
Use appropriate IEC power cord according to the local regulations to power
upand interconnect the pedestals.
The Power Supply Cord is the LSP3A Product Main Disconnecting Device,
It should be easily accessible at any time to Disconnect the pedestals from
the mains power supply.