User's Guide

LSP3A Clear User’s Guide
It is only for internal use and shall not be spread without permission
8
All components of the LSP3A system are contained within the LSP3A. At least two pedestals
are required for each EAS gate or passageway. A set of pedestals is known as a gate and may
consist of several pedestals. Please see section 4
“Installation” for more information.
The LSP3A models are built in a one frame:
 An LSP3A Electronics unit is used to control each pedestal. This electronics unit
generates the RF signal transmitted by the antennas and picks up the reply from the
RFID tag. If an activated RFID tag is detected, the electronics unit will activate the
LED/buzzer alarm
 These antennas are sensitive receivers used to detect the theft bit status and the AFI
value of the RFID tag as it passes through the EAS gate
 Visual and audible warning devices
 A remotely accessible people counter equipped with dual light barrier photoelectric
sensors.
To operate, the LSP3A Clear Model will only need an IEC power supply cable, avoiding
unnecessary mains cable wiring up.
An IEC Mains Supply Cord Outlet is available to allow daisy chaining. A series of up to 5
pedestals can be powered up from a single wall socket.