Product Manual

SECTION 9—WING/BUMPER
Part No 1122172 61 Everyday Series Wheelchairs/Sport Series Wheelchairs
SECTION 9—WING/BUMPER
 WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is
tightened securely - otherwise injury or damage may occur.
The bumper design creates a potential foot entrapment area. Ensure the occupant’s legs and
feet are properly secured during use. When transferring the occupant, ensure the feet do not slip
between the bumper and the footrests.
NOTE:ThefollowingproceduresareforTransformerwheelchairsONLY.
Installing/Removing the Wing/Bumper
NOTE:PSSA,PSST, andSPROwings/bumperarenotremovable.
NOTE:Forthisprocedure,refertoFIGURE 9.1.
Installing
1. Slidewing/bumperclampsontocastorhousingontheTransformer.Ensurethewingorbumperisevenonbothsides.
2. Tightenallenscrewssecurelyoneachside.
Removing
1. Loosenallenscrewsonwing/bumperclamps.
2. Slideupandremove.
FIGURE 9.1 Installing/Removing the Wing/Bumper
Wing/Bumper
Castor Housing
Allen Screws
Bumper/Wing
Clamp