Product Manual

SECTION 7—FOOTREST/ANTI-TIPPER
Everyday Series Wheelchairs/Sport Series Wheelchairs 54 Part No 1122172
Installing
1. Installthetwohalfclampsontoeithersideofthe
wheelchairframeapproximately2‐inches(5.08cm)
aboveexistingfootrestwithtwoprovidedallenscrews.
2. Repeatfortheoppositesideofthewheelchair.
3. Slidetheclamponraisedfootrestintothehalfclampsto
thedesiredheight.
4. Securelytightenthefourallen
screws.
FIGURE 7.2 Installing/Adjusting Optional Clamp on
Raised Footrest
Adjusting
1. Loosenthefourallenscrews.
2. Adjustclamponraisedfootresttothedesiredheight.
3. Securelytightenthefourallenscrews.
Replacing/Adjusting Optional Adjustable Angle One Piece Footplate
NOTE:Forthisprocedure,refertoFIGURE 7.3onpage54.
NOTE:ThisprocedureisforTerminatorEveryday(ED)
wheelchairsOnly.
Replacing the Footrest
1. Loosen,butDONOTremovethetwoallenscrewsthat
securethefootrest tothewheelchairframe.
2. Slidetheexistingfootresttubesoutofthewheelchair
frameandinstallnewfootrestbyreversingthisstep.
3. Positionthenewfootresttoadeterminedheight.
4. Tightenthetwoallenscrewsthatsecurethefootrest
to
thewheelchairframe.
5. Adjustthefootplatetothedesiredposition.Referto
AdjustingFootplateAngle
onpage 54and/orAdjusting
FootplateDepthonpage 54.
FIGURE 7.3 Replacing/Adjusting Optional Adjustable
Angle One Piece Footplate
Adjusting Footplate Angle
1. Loosen,butDONOTremovethefourflatscrewsandlocknutsthatsecurethefootplatetothetwofootresttubes.
2. Positionthefootplatetothenecessaryangletoaccommodatetheuser.
3. Retightenthefourflatscrewsandlocknuts.
NOTE:Thelocknutsshouldlieinthechannelofthefootplatehalfclamp.
Adjusting Footplate Depth
1. Loosen,butDONOTremovethefourflatscrewsandlocknutsthatsecurefootplatetothefootresttubes.
NOTE:Observetheangleoffootplateforreinstallation.
2. Movethefootplatetooneoftwopositions toaccommodatetheuser.
3. Retightenthefourflatscrewsandlocknuts.
NOTE:Thesettingsforpositioningthefootplateson
thehalf‐clampsmayvaryforeachenduser.
NOTE:Thelocknutsshouldlieinthechannelofthefootplatehalfclamp.
Allen
Screws
Wheelchair Frame
Outside
Footrest
Hoop
Half Clamp
Raised
Footrest
Allen Screws
Footrest
Tube
Flat
Screws
Footpla
Flat Screws
Angle
Depth
Height