Product Manual

SECTION 6—SEAT
Part No 1122172 51 Everyday Series Wheelchairs/Sport Series Wheelchairs
Adjusting Transformer Seat Height
NOTE:Forthisprocedure,refertoFIGURE 6.2onpage51
Adjusting Front Seat Height
1. Notetheorderofthemountingscrew,covedwashers,spacer,halfclampsandmountingscrew/threadedsleeveand
theirpositiononthewheelchairframeandfootresttubing(DetailʺAʺ,FIGURE 6.2).
2. Removethemountingscrew,covedwashers,spacer,halfclampsandmountingscrew/threadedsleeveonbothsidesof
thewheelchair.
NOTE:Thefootrest
tubingwillslideoncethehardwareisremoved.
3. Raise/lowerthefrontoftheseattothedesiredposition.
4. Adjustthefootrestheightifdesired.RefertoAdjustingtheTransformerFootrests
onpage 55.
5. Alignthefootresttubingadjustmentholeswiththe desiredwheelchairframeadjustmentholes.
6. InstallthehardwareremovedinSTEP2throughtheadjustment holesalignedinSTEP5.
7. Securelytightenallhardware.
Adjusting Rear Seat Height
1. Loosenthetwomountingscrewsonbothsidesofthefrontofthewheelchair(DetailʺAʺ).
2. Loosenthefouradjustmentscrewsonbothsidesoftherearofthewheelchair(DetailʺBʺ).
3. Adjustseathigherorlowertodesiredposition.Useatapemeasureorrulertoensurethat
bothsidesarethesameheight.
4. Securelytightenthefouradjustmentscrewsattherearofthewheelchairandthetwomountingscrewsatthefrontof
thewheelchair.
FIGURE 6.2 Adjusting Transformer Seat Height
DETAIL “A” -
FRONT VIEW
Wheelchair Frame
Footrest
Tubing
Coved
Washer
Mounted Screw/
Threaded Sleeve
Adjustment Holes
Half Clamp
Mounting Screw
Coved Washer
Half Clamp
DETAIL “B”
Adjustment
Screw
See Detail “A”