Product Manual

SECTION 5—WHEELS
Everyday Series Wheelchairs/Sport Series Wheelchairs 46 Part No 1122172
12. Closetheleftcamberclamp.RefertoOpening/ClosingCamberClampsonpage 34.
13. Rotatetherighttoeadjustmentringuntilthetabstopsagainsttheuppermetaltabonthecamberclamp.
14. Securelytightensetscrewonrighttoeadjustmentring.
15. RepeatSTEP7.
16. Perform oneofthefollowing:
•ToeIn/ToeOutMeasurementisWithin±1/8‐inch(.32cm)‐
i. ProceedtoSTEP17.
•Toe
In/ToeOutMeasurementisNotWithin±1/8‐inch(.32cm)‐
i. RepeatSTEP1.
ii. Loosenthesetscrewontherighttoeadjustmentring.
iii. RepeatSTEP3.
iv. RepeatSTEPS12‐16untiltoein/toe outmeasurementiswithin±1/8(.32cm)inch.
17. Ifdesired,repositioncamberinsertstothedesireddegreeofcamber.Refer
toAdjustingRearWheelCamberonpage 35.
FIGURE 5.21 Adjusting the Axle Tube - Adjustable Camber System
Replacing/Adjusting Castors
CAUTION
Changing the size/type of and/or repositioning the front castors can affect the performance of
the wheelchair. Contact Invacare at the telephone numbers on the back of this manual before
performing this procedure.
NOTE:Forthisprocedure,refertoFIGURE 5.22onpage47.
NOTE:Non‐suspensioncastorscannotbeadjustedastheymountinonepositiononly.
Camber
Clamp
Higher Degree of Camber
Axle Tube - Will Rotate Down only
Ground/Floor
90° Angle
Place “L” Square Here
Flat Edge of
Camber Tube
Lower Degree of Camber
Right Tab
Stopped
Against Upper
Edge of
Camber
Clamp
Right Toe Adjustment
Ring
Left Tab
Stopped
Against
Lower Edge
of Camber
Clamp
Left Toe
Adjustment
Ring
Camber
Clamp
Axle Tube - Will
Rotate Up only