Product Manual

SECTION 5—WHEELS
Everyday Series Wheelchairs/Sport Series Wheelchairs 38 Part No 1122172
FIGURE 5.11 Adjusting Toe In/Toe Out - Adjustable Camber System - Course Adjustment
NOTE:DONOTtigh tenthephillipsscrewontheotheradjustmentringatthistime.
NOTE:RepeatSTEPS1‐7ofthisprocedurefortheotheradjustmentringafterrepositioningthecamberinsert.RefertoAdjustingRear
WheelCamberonpage 35.
NOTE:Whenpositioningtheotheradjustmentring,rotatetheringuntilthestopisatthebottomoftheslotinthecamberclamp.The
rightandleftstopsMUSTbepositionedoppositetoeachotherorFineAdjustment
onpage 38will notworkcorrectly.
NOTE:Whentheleftadjustmentringisadjustedtoacamber,therightadjustmentringwillnottouchthecamberclampandwhenthe
rightadjustmentringisadjustedtotheothercambertheleftadjustmentringwillnottouchthecamberclamp.
Fine Adjustment
NOTE:Forthisprocedure,refertoFIGURE 5.12andFIGURE 5.13onpage39.
NOTE:Thisadjustmentisrequiredanytimethecamberinsertisrepositioned.
1. Openthecamberclamp.RefertoOpening/ClosingCamberClamps
onpage 34.
2. Slowlyrotatetheaxletubeuntilthestopontheoppositeadjustmentringispositionedattheoppositeendofthecamber
clamp.
3. Closethecamberclamp.RefertoOpening/ClosingCamberClamps
onpage 34.
NOTE:Rearwheelsareremovedfromthedrawingsforclarity,thereisnoneedtoremoverearwheelsfromthewheelchairduring
adjustment.
NOTE:FIGURE 5.13showsoneexampleofhowtheadjustmentringscanbepositioned.
FIGURE 5.12 Adjustable Camber System
Stop - Not touching
camber clamp
Adjustment Ring
Camber Clamp
Adjustment Ring
Camber Clamp
Stop - In position for one camber,
touching camber clamp
Stop - In position for one camber,
touching camber clamp
Adjustment Ring
Stop - Not touching
camber clamp
Adjustment Ring
Axle Tube - Rotates Up and Down