Product Manual

ManualsBrandsInvacare ManualsMobilityTop End Pro Basketball Wheelchair

SECTION 5—WHEELS

Part No 1122172 37 Everyday Series Wheelchairs/Sport Series Wheelchairs

Adjusting Toe In/Toe Out

Camber Tube With Single Camber

NOTE:Forthisprocedure,refertoFIGURE 5.9.

1. Openthecamberclamps.RefertoOpening/Closing 

CamberClampsonpage 34.

2. Slowlyrotatethecambertu beineitherdirectionuntil

therearwheelsareapproximatelyinastraightline.

3. Closethecamberclamps.RefertoOpening/Closing

CamberClampsonpage 34.

4. Measurethedistancebetweenthecenterlinesatthe

rearandfrontoftherearwheelsatapproximately12

inches(30.48cm)fromtheground/floor.Referto

DeterminingToeIn/ToeOut

onpage 36.

5. RepeatSTEPS1‐4untilthetoein/toeoutmeasurement

islessthan1/2‐inch(1.27cm)(0+

1/4‐inch(.63cm)for

maximumrollability).

FIGURE 5.9 Adjusting Toe In/Toe Out - Camber Tube

With Single Camber

Adjustable Camber System

Course Adjustment

NOTE:Forthisprocedure,refertoFIGURE 5.10andFIGURE 5.11onpage38.

NOTE:Thisprocedureisrequiredanytimetheaxletubeismovedfromthefactorysetpositionorisreplaced.

NOTE:Makethefollowingadjustmentforonecamberatatime.

1. Openthecamberclamps.RefertoOpening/Closing CamberClamps

onpage 34.

2. Loosenthephillipsscrewsthatsecuretheadjustmentringstotheaxletube.

3. Slowlyrotatetheaxletubeuntiltherearwheelsareapproximatelyinastraightline.

4. Closethecamberclamp.RefertoOpening/ClosingCamberClamps

onpage 34.

5. Measurethedistancebetweenthecenterlinesattherearandfrontoftherearwheelsatapproximately12inches(30.48

cm)fromtheground/floor.RefertoDeterminingToeIn/ToeOut

onpage 36.

6. RepeatSTEPS1‐4untilthetoein/toeoutmeasurementislessthan1/2‐inch(1.27cm)(0+

1/4‐inch(.63cm)formaximum

rollability).

7. Rotateeithertherightorleftadjustmentringuntilthe

stopontheringisatthetopoftheslotinthecamber

clampasshowninFIGURE 5.11andsecurelytighten

thephillipsscrewonthepositionedadjustmentring.

NOTE:Rearwheelsare

removedfromthedrawingsforclarity.

Thereisnoneedtoremoverearwheelsfromthewheelchairduring

adjustment.

NOTE:FIGURE 5.11showstwoexamplesofhowtheadjustment

ringscanbepositioned.

FIGURE 5.10 Adjustable Camber System

Camber Tube - Rotates Up and Down

Camber Clamps

Axle Tube - Rotates Up and Down