Product Manual

SECTION 4—BACK

Part No 1122172 31 Everyday Series Wheelchairs/Sport Series Wheelchairs

12. Adjusttheslackinthebackupholsterycoverandthensecuretotheseatpanfasteningstraps.

Back Height Adjustment (Adjustable Backs Only)

NOTE:Forthisprocedure,refertoFIGURE 4.7onpage31

NOTE:Observethetautnessofthebackupholsteryforreinstallation.

1. Unlatchthetwofasteningflapsthatsecurethetopofthebackupholsterytothebackpostsandremovefromtheback

posts.

 WARNING

Push pin MUST be protruding through hole in back post.

Ensure that both back post inserts are at the same height BEFORE reassembling the wheelchair.

2. Pressthepushpinontheback postinserttubeinandadjustthebackheighttooneoffourheightsdependingonoriginal

backheight:

*NOTE:Holesnumberedfrombottomtotopforreferenceonly.(Therearenonumbersonthebackposts.)

NOTE:Thereisa1‐inch(2.54cm)

adjustmentpinonthebackpostinserttube.Toraisebacktomaximumheight,firstmakeadjustment

tothebackpostinserts.

3. Reinstallthefasteningflaps ontothebackposts.

NOTE:Thefasteningflapwithlogoisfortheleftbackpost.

NOTE:Rightandleftisdeterminedbysittinginthe

wheelchair.

4. Adjustthenewbackupholsterytothedesiredtautness.RefertoAdjustableTensionBackUpholstery

onpage 29.

FIGURE 4.7 Back Height Adjustment (Adjustable Backs Only)

ORIGINAL BACK

HEIGHT

(IN INCHES)

9-11

(22.86 - 27.94 CM)

10-14

(25.40 - 35.56 CM)

12-16

(30.48 - 40.64 CM)

14 - 18

(35.56 - 45.72 CM)

16 - 20

(40.64 - 50.8 CM)

Hole* Number

1 9 (22.86 cm) 10 (25.40 cm) 12 (30.48 cm) 14 (35.56 cm) 16 (40.64 cm)

2 10 (25.40 cm) 11 (27.94 cm) 13 (33.02 cm) 15 (38.1 cm) 17 (43.18 cm)

3 11 (27.94 cm) 12 (30.48 cm) 14 (35.56 cm) 16 (40.64 cm) 18 (45.72 cm)

4 N/A 13 (33.02 cm) 15 (38.10cm) 17 (43.18 cm) 19 (48.25 cm)

5 N/A 14 (35.56 cm) 16 (40.64 cm) 18 (45.72 cm) 20 (50.8 cm)

Back Post

Insert

Hole

Number