Product Manual

Part No 1171735 3 Invacare® Matrx® PS
3 Usage
3.1 Installing the Invacare Matrx PS
1. Ensure the desired side of the outer cover is
exposed. Refer to Reversing the Outer Cover
on page 3.
2. Position the cushion so the material
identification tags (not shown) face the rear.
3. Align the hook and loop strips (not shown) on
the bottom of the cushion with those on the
wheelchair seat.
4. Position the cushion onto the wheelchair as far
back as possible.
5. Press down to ensure the hook and loop strips
are firmly engaged.
3.2 Reversing the Outer Cover
1. Unzip the outer cushion cover.
2. Remove the outer cushion cover.
3. Turn the outer cushion cover inside out to the desired side.
4. Install the cushion with inner cover into the outer cover with the waffled recess facing down.
4 Care and Maintenance
4.1 Cleaning
Outer Cover
The cover can be wiped clean with a damp towel.
The cover can be removed for laundering. Unzip the cover and carefully remove the foam with inner
cover. The zipper should be closed prior to laundering.
Dry clean or machine wash using the delicate cycle and hang dry or tumble dry on low.
Inner Cover
The inner cover can be wiped clean with a damp cloth. The inner cover should not be removed from the
foam.
4.2 Inspection
Visually inspect parts including upholstery materials, foams (if accessible), and plastics, for deformation,
corrosion, breakage, wear or compression.
5 After Use
5.1 Reuse
Rear
Front
WARNING
DO NOT continue to use this product if problems are discovered. Corrective maintenance can
be performed at or arranged through your equipment supplier.
WARNING: Risk of Injury
Always have a dealer inspect the product for damage before transferring the product to a
different user. If any damage is found, DO NOT use the product. Otherwise injury may occur.