Product Manual

8 PACKAGING, HANDLING AND SET-UP
Invacare
®
IVC
™
Model BAR600IVC Bariatric Bed 44 Part No 1123842
Inspecting the Bed
1. Check all electrical connections on junction box at foot end to ensure that all motors are plugged into the correct locations.
2. Plug the junction power box cord into a 110-volt outlet.
3. If equipped with a crossover cable, plug in crossover cable (See caution label in Detail “A” in FIGURE11).
4. Before placing bed into use, test the bed by operating it through all phases of operation.

WARNING
The removal and installation of cables are to be performed by a qualified technician.
Before installing the connector into the junction box, be sure the side with the locking tab is facing downward - otherwise,
injury or damage may occur.
CAUTION
All cable connections MUST be aligned properly. Align locking levers with locking tabs for proper connection.
Mis-alignment of cable connections will cause permanent product damage.

For this procedure, refer to FIGURE11.
All connectors will arrive plugged into the junction box.
CAUTION
All cable connections MUST be aligned properly. Align locking levers with locking tabs for proper connection.
Mis-alignment of cable connections will cause permanent product damage.