PEDIATRIC WALKER - Sportrunner MARCHETTE POUR ENFANT - Sportrunner ANDADOR PEDIATRICO - Sportrunner Refer to page 2. Se référer à la page 12. Refiérase a la página 22.
Pediatric Walker - Sportrunner™ Model Number 6210 - Small Size Frame Model Number 6211 - Large Size Frame The Pediatric Walker has a lifetime limited warranty Features: • Can be converted from a reverse postural (pulling) walker to a foward (pushing) walker.
SAVE THESE INSTRUCTIONS NOTE: Check all parts for shipping damage. In case of shipping damage, DO NOT use. Contact Dealer/Carrier for further instruction. SAFETY SUMMARY The following recommendations are made for the safe operation of the PEDIATRIC WALKER - Sportrunner™: GENERAL WARNING DO NOT install or use this equipment without first reading and understanding these instructions.
SAFETY SUMMARY (continued) FOLDING/ASSEMBLY WARNINGS After unfolding or assembling walker, ensure that walker is securely locked in OPEN position and level to the ground BEFORE using. DO NOT hang anything on either the left or right side frames or the left and right handle bars. This will cause side frames or handle bars to bend downward and prevent walker from locking into place when fully opened. This may also cause walker to tip, resulting in injury or damage.
Handle UNFOLDED Release Button Handles Height Adjustment Holes Lock Bar Walker Frame Snap Buttons FOLDED Walker Frame FIGURE 1 - OPENING/FOLDING THE WALKER ADJUSTING THE HANDLE BARS (FIGURE 2) NOTE: Refer to INSTALLATION WARNINGS in the SAFETY SUMMARY in this instruction sheet. 1. Depress both snap buttons and raise/lower the handle to the desired height. 2. Ensure both snap buttons fully protrude through one (1) of seven (7) sets of height adjustment holes in the front frame tube. 3.
WHEELS (FIGURE 3) Replacing The Wheel NOTE: Refer to INSTALLATION WARNINGS in the SAFETY SUMMARY in this instruction sheet. 1. Remove the set screw from the wheel insert. 2. Perform one (1) of the following: One-Way Wheels: Remove the existing mounting screw, washer and spacer that secure the existing one-way wheel to the wheel insert. Two-Way Wheel: Remove the existing mounting screw, washer, bushing and spacer that secure the existing two-way wheel to the wheel insert. 3.
Bushing (Two-Way Wheel Only) Wheel Mounting Screw Mounting Screw Spacer Tube Frame Washer Locknut Wheel Insert Set Screw Washer FIGURE 3 - REPLACING THE WHEELS/REPLACING THE ONE-WAY WHEELS WITH TWO-WAY WHEELS CONVERTING THE REVERSE POSTURAL (PULLING) WALKER TO A FOWARD (PUSHING) WALKER (FIGURE 4) NOTE: Refer to INSTALLATION WARNINGS in the SAFETY SUMMARY in this instruction sheet. NOTE: Walker is shipped in the reverse postural (pulling) walker configuration.
1. Remove the four (4) mounting screws, washers and locknuts that secure the four (4) wheel inserts to the walker frame. Remove the four (4) wheel inserts. 2. Install the right two-way wheel insert into the right rear frame tube. Secure with mounting screw, washer, and locknut. 3. Install the left two-way wheel insert into the left rear frame tube. Secure with mounting screw, washer, and locknut. 4. Install the right one-way wheel insert into the left front frame tube.
REPLACING THE WALKER PAD (FIGURE 5) NOTE: Refer to INSTALLATION WARNINGS in the SAFETY SUMMARY in this instruction sheet. 1. Separate the hook and loop strips and remove the pad cover. 2. Remove the EXISTING walker pad crossmember. 3. Slide the NEW walker pad over the crossmember. 4. Reinstall the pad cover and secure with hook and loop strips.
Rear Left Frame Tube Wheel Insert Crutch Tip FIGURE 6 - INSTALLING THE CRUTCH TIPS REPLACING THE GRIPS (FIGURE 7) NOTE: Refer to INSTALLATION WARNINGS in the SAFETY SUMMARY in this instruction sheet. 1. Remove the EXISTING grip and end plug. Discard both. 2. Apply a thin coat of hair spray on the inside of the NEW grip and on to the handle. NOTE: This application will make it easier to slide the grip onto the push handle bar. 3. Slide NEW grip onto one end of the push handle. 4. Install NEW end plug.
LIFETIME LIMITED WARRANTY Invacare warrants this product to be free from defects in materials and workmanship PLEASE NOTE: THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY WITH FEDERAL LAW APPLICABLE TO PRODUCTS MANUFACTURED AFTER JULY 4, 1975. This warranty is extended only to the original purchaser/user of our products. This warranty gives you specific legal rights and you may also have other legal rights which vary from state to state.
Invacare Corporation • ONE INVACARE WAY • Elyria, Ohio 44036-4028 USA • (800) 333-6900 Invacare Canada, Inc. • 5970 Chedworth Way • Mississauga, Ontario L5R 3T9 Canada (800) 668-5324 Form No. 00-105 P/N 1098350 Rev.
