User's Manual

Chapter 4 Using MiroView™
4- 16
4.3.6 Data Upload
After the capsule endoscopy procedure, upload the data from the
Receiver to the MiroCam® system via MiroView™ Operator. Click
the button to upload the data from the Receiver.
After the image data in the MiroCam® Receiver has been
successfully uploaded, enter the List Mode and check if the new Case
has been created.
- Double click the icon to run MiroView™ Client.
- Select the newly uploaded Case and enter the Review Mode.
- Play the case to check the uploaded image data.
CAUTION
If you fail to upload the data from the Receiver,
disconnect and reconnect the USB cable from the
workstation, then turnoff the MiroCam® Receiver
and turn it back on. Try uploading again. If the
problem persists, please contact IntroMedic.
NOTE
If the user uploads a patient data which has been
uploaded before, an error message ‘Data has been
previously uploaded. Would you like to upload
again?’ will appear.
NOTE
Upload progress will be displayed. The user can
stop the process while uploading by clicking the
button.