User's Manual

Safety Information Chapter 1
1- 10
n DO NOT USE in moist or damp places.
n DO NOT operate the equipment with wet hands.
n Avoid using the equipment in extreme temperatures or humid
environments.
n DO NOT keep the equipment or carry out the procedure in places such
as areas exposed to direct sunlight, vicinity of heaters, vicinity of
chemical materials or gases, areas moist/damp or dusty, or poorly
ventilated areas.
n DO NOT disassemble or open the equipment without permission. This
will invalidate the warranty.
n DO NOT carry out the procedure in areas with high vibrations or in
environments where high electro-magnetic waves are generated.
n DO NOT pull out the power cord by grabbing the cable. When
disconnecting the power cord, grasp the plug, and pull out. This
prevents short-circuits, disconnection, or cord damage.
n CAUTION: Verify that the power voltage supplied from the power
receptacle matches with the voltage the system requires. Check
Voltage and Frequency on the AC/DC adaptor.
n CAUTION: Turn off the power switch before connecting the sensor pad.
n DO NOT discard sensor pads, cables and connectors with general
waste. Discard separately as industrial or medical waste.
n CAUTION: Discard the battery according to the regulations of industrial
waste. DO NOT discard with general waste.
n DO NOT carry out the procedure simultaneously with other procedures
using medical products or equipment.
n DO NOT use for purposes other than medical treatment.
n DO NOT connect the USB cable to the receiver while the receiver’s
data cable and sensor pads are still connected
n DO NOT charge the receiver while the receiver’s data cable and
sensor pads are still connected.