Installation and User's Guide Network Adapter

Page 46 of 83
The following tests are run when the test command is executed and the
adapter is connected to a network.
• qfe register
• MAC Internal Loopback
• 100MBit PHY Loopback
• 100MBit TP Loopback
• 10MBit XCVR Loopback
Note: To test other channels of the adapter, you will need to execute the test
command separately on each channel.
Note: After testing is complete use the following command:
ok setenv diag-switch? False
to turn off diagnostic mode. If diag-switch? is left as true the time for the
system to initialize will increase.