Installation and User's Guide Network Adapter

Page 40 of 83
Device at Description Notes
HDD Node0 Shared Disk Drive 1 mounted
on the removable caddy. The
drive has an SCA connector
that permits hot swap.
SCSI-ID = 0
Terminator = Disabled
TermPwr = Off
SCA-Adapter Node0 Adapter fixed at the rear of
the backplane on top section.
Terminator = Auto
Internal Cable Node0 SCSI-68 pin ultra-wide cabel
8’ long that connects the
SCA-adapter (IN) and the
ITI-8241C-R (Channel A)
ITI-8241C-R Node0 The rear I/O Transition card
has a SCSI channel A internal
connector and an external
micro connector.
This card is plugged at
the rear of the ITI-
8241C-S.
External Cable
(One End)
Node0 Micro connector SCSI
external cable
External Cable
(Other end)
Node1 Micro connector SCSI
external cable
ITI-8241C-R Node1 The rear I/O Transition card
has a SCSI channel A internal
connector and an external
micro connector.
This card is plugged at
the rear of t he ITI-
82141C-S.
Internal Cable Node1 SCSI-68 pin ultra-wide cable
8’ long that connects between
SCA-adapter (IN) and ITI-
8241C-R (channel A)
SCA-Adapter Node1 Adapter fixed at the rear of
the backplane on top section.
Terminator = Auto
DHH Node1 Shared Disk Drive 1 mounted
on the removable caddy. The
drive has an SCA connector
that permits hot swap.
SCSI-ID=0
Terminator = Disabled
TermPwr = Off
Table 6: SUNCluster™ Cabling and Termination Details
Additional configurations are possible, additional
diagrams may be added in a future manual revision.