Installation and User's Guide Network Adapter

Page 22 of 83
Configuring Ethernet for Rear I/O
To configure the ITI-8241C-S Ethernet to exit the rear of the system cabinet
via the ITI-8241C-R rear I/O module, use the following procedure:
§ Locate J6, J7, J8 and J9. (See Figure 2 for jumper locations)
§ Move the jumpers for each port to the Front “F” or Rear “R”
position.
Each port can be configured for front I/O or rear I/O.
J9 = Port 3 J8 = Port 2 J7 = Port 1 J6 = Port 0
Figure 7: Ethernet Configured for Front I/O
J9 = Port 3 J8 = Port 2 J7 = Port 1 J6 = Port 0
Figure 8: Ethernet Configured for Rear I/O
R F R F R F R F
R F
R F R F R F