User's Manual
Table Of Contents
- REMOTE UNIT
- INTENTIONALLY BLANK
- Table OF CONTENTS
- CUSTOMER SUPPORT
- Bin-Sense REMOTE CERTIFICATIONS
- MANUFACTURER’S WARRANTY
- SAFETY
- OVERVIEW
- INSTALLATION
- INSTALLATION TIPS
- REMOTE UNIT INSTALLATION
- 1. Place the Remote unit on the top of the bin with the lid latches and link cables pointing towards the ground.
- 2. Place the unit where it as clear line-of-site to the Master unit external antenna and is easily accessible for future service and maintenance. The magnetic feet will hold the unit in place on the roof of the bin.
- 3. Mount the solar panel on the bin facing the direction of maximum sunlight (face south in the northern hemisphere, face north in the southern hemisphere). The solar panel has magnetic feet and can be mounted directly on the bin roof, or on a mounti...
- 4. Make sure the Remote unit solar panel connection can reach to the solar panel location.
- 5. Connect the Remote unit sensor link cable to all the sensing cables and to any other Bin-Sense accessories (e.g. Fan Controllers). You’ll need to use a terminal box or splitter to connect more than one device to the sensor link cable.
- 6. Install the three AA batteries in the Remote unit. Secure the batteries in place with the hook-and-loop strap.
- 7. Connect the Remote unit solar panel connection to the solar panel.
- 8. Refer to the Bin-Sense Live Startup Manual for further instruction on how to get the Bin-Sense Live system up and running.
- OPERATION
- INTENTIONALLY BLANK
Page 4 March 2022 Version 1.0 www.binsense.com
BIN-SENSE REMOTE CERTIFICATIONS
FCC ID: 2AUTY-106103RU-V06
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly Approved by IntraGrain Technologies Inc. could void the user’s
authority to operate the equipment.
CAUTION: This equipment has been tested and found to comply with the limits for a class a digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
WARNING: RADIO-FREQUENCY RADIATION EXPOSURE RISK. THIS EQUIPMENT COMPLIES WITH
RADIATION EXPOSURE LIMITS PRESCRIBED FOR AN UNCONTROLLED ENVIRONMENT FOR FIXED
AND MOBILE USE CONDITIONS. THIS EQUIPMENT SHOULD BE INSTALLED AND OPERATED WITH A
MINIMUM DISTANCE OF 20 CM BETWEEN THE RADIATOR AND THE BODY OF THE USER OR NEARBY
PERSONS. THIS TRANSMITTER MUST NOT BE CO-LOCATED OR OPERATING IN CONJUNCTION WITH
ANY OTHER ANTENNA OR TRANSMITTER EXCEPT AS AUTHORIZED IN THE CERTIFICATION OF THE
PRODUCT.