Installation Instructions

4. Installation Procedures
152
WiBAS G5 micro-BS / evo-BS and Omnidirectional 360
Antenna with MTK-DMA-BX Mounting Kit, Continued
Procedure
How to install the WiBAS
TM
G5 micro-BS / evo-BS to HANT2628360V
antenna, proceed as follows:
Step
Action
1
Perform the following actions:
 Pass the steel hose clamps through the pole bracket
respective openings, as shown below:
For pole diameter 48 mm up to 159 mm
For pole diameter 160 mm up to 300 mm
 Use the tool with M5 hexagon female bit to fully tighten the
hose clamps worm screws.
Do not over tighten. Adjust the tool for applying maximum
tightening torque 7 Nm.
Continued on next page