Installation Instructions

4. Installation Procedures

144

WiBAS OSDR-HUB and Omnidirectional 360 Antenna with

OSDR-360-ANT-MNT-KIT Mounting Kit, Continued

Procedure

How to install the HANT2628360V antenna with adaptation plate (OSDR26-

360-ANT-ADAPT-KIT or OSDR28-360-ANT-ADAPT-KIT) to WiBAS

OSDR-

HUB 26 / 28 GHz and then to mounting kit (OSDR-360-ANT-MNT-KIT),

proceed as follows:

Step

Action

Perform the following actions:

 Pass the steel hose clamps through the pillar bracket

respective openings, as shown below:

 Use the tool with M5 hexagon female bit to fully tighten the

hose clamps worm screws.

Do not over tighten. Adjust the tool for applying maximum

tightening torque 7 Nm.

Perform the following actions:

 Place mounting bracket onto the pillar bracket (A) and then

install the set of pole mounting kit packing list materials, as

shown below:

 Use the tool with M8 hexagon female bit to slightly tighten the

screws.

The maximum tightening torque is applied to the last

step.

Continued on next page