Installation Instructions

4. Installation Procedures
122
WiBAS G5 micro-BS / evo-BS and Sectoral 90 or 180
Antenna with MTK-DMA-BX Mounting Kit, Continued
Procedure
Prerequisite
Take into account the steps 2, 5, 6, 7 and 8 as
described in procedure of WiBAS OSDR-HUB and
Sectoral 90 Integrated Antenna on page 83.
How to install WiBAS
TM
G5 micro-BS / evo-BS to HANT28180V or
HANT28180H antenna, proceed as follows:
The installation procedure for sectoral 90
0
or 180
0
is common.
Step
Action
1
Perform the following actions:
 Pass the steel hose clamps through the pole bracket
respective openings, as shown below:
For pole diameter 48 mm up to 159 mm
For pole diameter 160 mm up to 300 mm
 Use the tool with M5 hexagon female bit to fully tighten the
hose clamps worm screws.
Do not over tighten. Adjust the tool for applying maximum
tightening torque 7 Nm.
Continued on next page