Installation Instructions

Appendix B – Terminating Cables
258
Power Supply, Continued
Procedure for
AC power
supply cable
How to terminate the 3 x 0.75 mm
2
AC power supply cable to PONE-OD67-
AC connector, proceed as follows:
How to terminate the AC power supply cable to POE-HP-OD-AC
power injector connector please refer to packing box installation
instructions leaflet.
Step
Action
1
Perform the following:
 Strip approx. 10 mm from the cable’s outer sheath (A).
 Strip approx. 4 mm from each wire insulation (B).
 Pass the cable through the parts of gland (C).
 Solder the 3 pins to the connector (D) taking in consideration
the following:
 The Yellow/Green wire must be soldered to the pin shown
below.
 The remaining two black wires are for live (L) and neutral
(N). Both wires must be soldered to the other two pins.
There is no polarity concern regarding these two
specific wires.
Continued on next page